Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. This pack contains:
‚Ģ 340mm of Straight Fencing
‚Ģ 2 x 102mm lengths of Ramp Fencing
‚Ģ 1 Large and 1 Small Gate
‚Ģ 2 Ramp Gates
‚Ģ 1 Ticket Gate

Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. This pack contains 680mm of fencing.

This superb kit is modelled on the overall roof at Ashburton, Devon. Designed for use with Station Building kit (Ref 204), it will enable you to build a GWR station quickly and easily. Although a specific prototype, the design is typical of many other regions including some tropical countries where it was intended to shelter passengers from the sun as well as rain. Supplied with some pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint: 153mm x 82mm

Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. This pack contains Approximately 476mm of fencing.

Standard GWR Signal Box, numbered 8/28b by the Signalling Record Society, installed from the 1920's up until WW2. Our kit includes interior details such as levers, stove , desk and brass etched window frames. Supplied with some pre-coloured parts, painting and/or weathering can add realism; glue is required to complete this model. Footprint 60mm x 25mm

After loading, open wagons were checked for height using this simple gauge to ensure that loads did not hit bridges etc. and therefore were usually placed near the yard exit. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model.

Keep on the right side of health and safety regulations - use these double rail stanchions in locations wherever the general public are allowed. Pack contains 20 injection moulded supports and approx 2 x 400mm length of nickel silver railing.

Always difficult to scratchbuild, these realistic features will enhance any industrial installation that needs a single rail safety barrier. Pack contains 20 injection moulded supports and 400mm length of brass wire.

Used for light lifting work in goods depots and other yards. Also to be found inside goods sheds for unloading wagons. Chain included; kit requires glue and paints to complete.

This kit contains the parts to make 1 Lower Quadrant Home or Distant Signal. Glue and paints required to complete model.

This kit contains the parts to make 1 Upper Quadrant Home or Distant Signal. Glue and paints required to complete model.

If you are a scratchbuilder or want to modify one of our N Gauge kits, this is range for you. Ratio's Builder range has been extended here to include all accessory packs from the Trackside range that you can use to this end. Kit includes parts to make: 1 Industrial chimney approx 120mm High, 20mm x 20mm at base, and 1 Tank 24mm Long x 14mm Wide and approx 34mm High.