Water towers with cranes were generally used on platforms and in other areas with restricted space. This kit will build either a tower with a flat top or the familiar GWR conical type. Includes stove, water crane etc. as well as etched brass chain and ladder; glue and paints required to complete model. Use the Ratio Water Crane and Fire Devil Kit 413 if further cranes are required.

A raised water supply for an engine shed or to supply platform water cranes (See Ratio 413 and Peco LK-2 Water Cranes, also Ratio 550 Water Troughs). Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint: 66mm x 55mm.

Often seen in the loco yard or near the platform end. Use LK-2 Water Cranes if additional cranes are required.

A fairly universal design seen at many steam loco depots. The kit includes water gauge, water crane, fire buckets and lamp. Use the Ratio 413 Water Crane and Fire Devil kit if further cranes are required. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint 90mm x 60mm

Stations often had these Water Cranes at the end of the platforms so the locomotives could be refilled without detaching them from the train. Also included is a coke brazier, called a 'fire devil' to keep the cast iron pipe from freezing up during the winter. These cranes were usually supplied by a large water tank (see Ratio 506 and 551 and Wills SS34 kits). Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model.

Usually supplied by a water tower (See LK-1, Ratio 506, 540, 551 and Wills SS34 kits).

Add interest to your village centre with these generic structures. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. footprint: 76mm x 59mm.

A building to complement the SSAM101 Blacksmith Set. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint: 84mm x 55mm.

This type of urinal, consisting of cast iron screens but otherwise open to the elements was found at busy locations in city centres and railway stations. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint: 92mm x 34mm.

Model of a Victorian style cast iron bridge, designed to be used with the SS64 abutments kit. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Span: 110mm

This Plate Girder Bridge kit can be made up to suit the length of span required, and is therefore particularly useful where roads/ railways cross at an angle other than 90 degrees or where a long bridge is required. Maximum girder length 352mm. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model.

This easily assembled kit makes a model of a Ransome and Rapier well type turntable. It can be used with either Code 100 or Code 75 track. As supplied it is hand operated, but a motorising kit will be available soon. Full instructions supplied.