Each pack contains 4 loads; as supplied they each fit a standard wagon. The mouldings are designed to be split in half so that one and a half mouldings can be used to fit a 15ft open wagon.

Footprints: Greenhouse 56mm x 41mm, Cold Frames 26mm x 25mm each (glazing included). Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model.

2 huts and a privy as seen on allotments everywhere. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Combined footprint: 94mm x 38mm

A small signal box as would be seen at a small country station, or controlling the exit from a yard or industrial area. Use SS89 Point Rodding to fill in this important detail on your layout. Footprint:48mm x 36mm.

Makes 4 Ground Signals, glue and paints required to complete model.

The use of old coach bodies as stores, mess huts or even homes was common. Clutter included, huge scope for adding detail to such a scene. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint 115mm x 40mm

Usually used for storage around the station or goods yard, they often can be found being used as sheds or on farmland. Clutter included; supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint 176mm x 90mm

Based on LNER 12 ton Goods Van

If you are a scratch-builder or want to modify one of our N Gauge kits, this is range for you. Ratio's Builder range has been extended here to include all accessory packs from the Trackside range that you can use to this end. An essential item on any property, this pack of Gutters, Soffits and Downpipes will provide drainage for up to 4 Terraced house fronts.

Pack includes: 432mm of guttering, 465mm of soffits, 4 x 71mm down pipes, 1 angled water pipe and 14 down pipe brackets.

500 of these wagons (diagram O13) were built in 1913. Used for short run traffic in Cornwall and to carry china clay to potteries and paper mills. Final withdrawal took place in the late 1950s. These finely moulded plastic wagon kits come complete with pin point axle wheels and bearings. Glue and paint will be required, along with appropriate transfers. Additional parts to enable the vehicle to be modelled incorporating modifications made to the prototypes during their working life are included where appropriate.

The GWR introduced a fleet of these vans (diagram Y4) in the early 1920s. These vans could still be seen in service into the 1950s. These finely moulded plastic wagon kits come complete with pin point axle wheels and bearings. Glue and paint will be required, along with appropriate transfers. Additional parts to enable the vehicle to be modelled incorporating modifications made to the prototypes during their working life are included where appropriate.