Laser cut wooden kit with plastic chimney pot detail and glazing sheet.

A craft knife, needle files, glue (impact adhesive or PVA work well. Superglue can also be used apart from the glazing) and paints are required.

A signalbox suitable for a small country station, based on Highley on the Severn Valley Railway (with thanks to the SVR for allowing access to measure it).

Technical Specifications

Length 65mm (including steps)

Width 32mm

Laser cut wooden kit with plastic chimney pot detail.

A craft knife, needle files, glue (impact adhesive or PVA work well. Superglue can also be used apart from the glazing) and paints are required.

The lineside hut kits contains components for two buildings. Carefully designed and thought through, these kits are a delight to build.

 

Pair of detailed Tunnel Mouths, with separate wings walls for optional positioning. Matching Stone Walling is also available (NB-40).

Pair of detailed Tunnel Mouths, with separate wings walls for optional positioning. Matching Stone Walling is also available (NB-40).

Kit contains detailed plastic parts, rail and electrical contacts, plus full instructions. A motorising kit will be available soon.

This easily assembled kit makes a model of a Ransome and Rapier well type turntable. It can be used with either Code 100 or Code 75 track. As supplied it is hand operated, but a motorising kit will be available soon. Full instructions supplied.

This Plate Girder Bridge kit can be made up to suit the length of span required, and is therefore particularly useful where roads/ railways cross at an angle other than 90 degrees or where a long bridge is required. Maximum girder length 352mm. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model.

Model of a Victorian style cast iron bridge, designed to be used with the SS64 abutments kit. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Span: 110mm

This type of urinal, consisting of cast iron screens but otherwise open to the elements was found at busy locations in city centres and railway stations. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint: 92mm x 34mm.

A building to complement the SSAM101 Blacksmith Set. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint: 84mm x 55mm.

Add interest to your village centre with these generic structures. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. footprint: 76mm x 59mm.

Usually supplied by a water tower (See LK-1, Ratio 506, 540, 551 and Wills SS34 kits).