As with the PECO Streamline track system we use the unique double-foot Code 55 rail for robustness, and also for the finer appearance of the track. This means that both Setrack and Streamline can be connected together. We have started with just the one radius, no. 2, at 310mm/12.2in., and the length of the medium radius Streamline turnout (SLU1295 and SLU1296) is the same as one standard and one small straight section. That will allow a siding to be inserted into a loop of the Setrack using the Streamline turnout without upsetting the geometry. Modellers should use the PL82 Pecolectrics Power Feed Joiners to connect power to the track: the joiners at one end of two pieces of track can easily be pulled off to allow the Power Feed Joiners to connect up. All Setrack products are supplied in hanging packs containing either 4 or 8 pieces and sold to you in singles.

Technical Specifications:

Length TBC
Radius TBC
Frog angle TBC

Code 55

Use SL-310 metal joiners and SL-1208 joining sleepers. Use SL-311 insulating joiners to create isolated track sections (if using DCC control these are not required).

One of the great advantages of TT:120 is that the 12mm gauge track correctly scales out as standard (4' 8.5") gauge, as used all over Britain's railway network. The ingenious rail section of PECO code 55 combines strength and durability with a highly realistic appearance – In TT:120 the visible height of the rail correctly represents 113lb flat bottom rail. The flexible sleeper base is detailed with fine wood grain and spikes through British Railways’ BR1 baseplates under the rails, a combination that continues to be widely used on Britain’s railways.

Technical Specifications:

Length 135mm
Radius 466mm
Frog angle 11.25 degrees

Code 55

Use SL-310 metal joiners and SL-1208 joining sleepers. Use SL-311 insulating joiners to create isolated track sections (if using DCC control these are not required).

One of the great advantages of TT:120 is that the 12mm gauge track correctly scales out as standard (4' 8.5") gauge, as used all over Britain's railway network. The ingenious rail section of PECO code 55 combines strength and durability with a highly realistic appearance – In TT:120 the visible height of the rail correctly represents 113lb flat bottom rail. The flexible sleeper base is detailed with fine wood grain and spikes through British Railways’ BR1 baseplates under the rails, a combination that continues to be widely used on Britain’s railways.

Technical Specifications:

Length 135mm
Radius 466mm
Frog angle 11.25 degrees

Code 55

Unifrog

Use SL-310 metal rail joiners and SL-1208 joining sleepers.

One of the great advantages of TT:120 is that the 12mm gauge track correctly scales out as standard (4' 8.5") gauge, as used all over Britain's railway network. The ingenious rail section of PECO code 55 combines strength and durability with a highly realistic appearance – In TT:120 the visible height of the rail correctly represents 113lb rail, which continues to be widely used on Britain’s railways. The turnouts conform to NEM standards and the medium radius geometry is a close match to British Railways’ B6 standard.

Technical Specifications

Length - 180mm

Exit angle - 11.25¬?

Radius - Nominal 922.6mm/36.3"

The NEW West Highland Line Station Building Laser-Cut Kit

The NEW West Highland laser-cut wood kits, all based on buildings on the existing West Highland Line extension between Fort William and Mallaig in Scotland. In fact Arisaig station was the inspiration for these attractive models, a delightful station on a very scenic and popular route, famous for many reasons but likely to be moist memorable for its role in the Harry Potter films. It is a route that has become a firm favourite with modellers so these kits will certainly be welcomed by many and be the inspiration for a number of new layout builds for sure.