A common style of fencing found in many locations. Length: 840mm. Glue is required to complete this model.

A common style of fencing found in many locations. Length: 840mm. Glue is required to complete this model.

These simple kit lamps can represent oil, gas or electric lamps. Supplied in a pack 4; supplied with some pre-coloured parts, painting and/or weathering can add realism; glue is required to complete this model.

This common type of water tower is usually found tucked away and used to supply individual water cranes (2 included with kit - Ratio Water Crane kit 212 is available if more are required). The water flow was controlled from the hand wheels on the cranes. Supplied with pre-coloured parts, painting and/or weathering can add realism; glue is required to complete this model. Footprint 34mm x 29mm

This basic crane is an essential for all station yards, often found inside goods sheds or on loading banks. Used to lift loads up to 1 ton, the boom can be swung round on its base to transfer goods from road to rail vehicles. Supplied with some pre-coloured parts, painting and/or weathering can add realism; glue is required to complete this model. Base Diameter: 25mm

Stations often had these Water Cranes at the end of the platforms so the locomotives could be refilled without detaching them from the train. Also included is a coke brazier, called a 'fire devil' to keep the cast iron pipe from freezing up during the winter. These cranes were usually supplied by a large water tank (see Ratio Water Tower kits 215, 256 and Loco Servicing Depot kit 206). Supplied with some pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model.

10 Telegraph poles, these also carried railway bell codes and phone connections between signal boxes and stations as well as GPO lines. Height approx 50mm

Kit for 2 Platform Ramps to match Ratio Straight Platform Sections kit (Ref 209). Supplied with some pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint: 120mm x 40mm each.

Kit contains parts to make a 240mm long and 40mm wide platform; easily extended by using further kits. Use Ratio Platform Ramps kit 210 with these platforms. Supplied with some pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model.

Apex canopy with valancing, stanchions and girders. The glazed sections can be placed at will. Although typical of GWR designs, this canopy can be used for almost any railway company. Supplied with some pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint: 200mm x 43mm

This superb kit is modelled on the overall roof at Ashburton, Devon. Designed for use with Station Building kit (Ref 204), it will enable you to build a GWR station quickly and easily. Although a specific prototype, the design is typical of many other regions including some tropical countries where it was intended to shelter passengers from the sun as well as rain. Supplied with some pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint: 153mm x 82mm

Complements your Engine Shed (See Ratio Kit 203). Kit includes a rectangular water tower, water crane, coaling stage with coal staithes and hoist with buckets. Supplied with some pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Footprint: 90mm x 30mm.