To fit under the Ratio Locomotive Lifting Hoist (545) or Overhead Traversing Crane (546) to allow them to run along tracks (not included). The kit makes a pair of rolling underframes. Length 61mm.

Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. This pack contains:
‚Ģ 1600mm of fencing
‚Ģ Includes road and rail gates.

2 brick built chimney stacks with pots in kit form. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model.

Adds the finishing touches to any signal box (See Ratio 500, 503, 536, 552 and Wills SS48 kits); it contains all you need to fit out a typical signal box including a 20-lever frame and a level crossing operating wheel. Glue and paints required to complete model.

Pack includes 24 9mm x 16mm classic Great Western style signal box windows.

4 x 143mm lengths of laddering.

Pack of 2 which can also be used as cold frames. Approximately 32mm long and 22mm wide each. Glue and paints required to complete model.

Classic style fencing modelled on a GWR design, but still seen also in many other places, around parks, public buildings, monuments etc. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. This pack contains 700mm of fencing.

Classic style fencing modelled on a GWR design, but still seen also in many other places, around parks, public buildings, monuments etc. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. This pack contains:
‚Ģ 2 x 100mm lengths of ramp fencing
‚Ģ 8 assorted gates

Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model. Our model faithfully captures the mitred edges of the prototype; this pack contains 600mm of fencing.

Kit includes:
‚Ģ 2 x 120mm ramps (1 L/H, 1 R/H)
‚Ģ 2 large gates and 2 small gates

After loading, open wagons were checked for height using this simple gauge to ensure that loads did not hit bridges etc. and therefore were usually placed near the yard exit. Supplied with pre-coloured parts although painting and/or weathering can add realism; glue is required to complete this model.